注册 登录  
 加关注
   显示下一条  |  关闭
温馨提示!由于新浪微博认证机制调整,您的新浪微博帐号绑定已过期,请重新绑定!立即重新绑定新浪微博》  |  关闭

木兰空间

万里赴戎机,关山度若飞

 
 
 

日志

 
 

【转载】富兰克林格子脖套  

2016-10-22 10:54:38|  分类: 围巾、帽子 |  标签: |举报 |字号 订阅

  下载LOFTER 我的照片书  |
本文转载自maomao《富兰克林格子脖套》
富兰克林格子脖套 - maomao - 我随心动


富兰克林格子脖套 - maomao - 我随心动


富兰克林格子脖套 - maomao - 我随心动


MATERIALS
Yarn

Plucky Knitter Traveler [65% merino, 20% silk, 15% yak; 320 yd/skein]; color: 
spacer [C1] Rouge; 1 skein
spacer [C2] Smokey the Bear, 1 skein
spacer [C4] Sounds Like a Carnival; 1 skein
spacer [C5] Pollen; 1 skein*
Plucky Knitter Primo Sport [75% merino, 20% cashmere, 5% nylon; 275 yd/skein]
spacer [C3] Oatmeal; 1 skein
*Please note that there are exactly four (four!) rounds of C5 in the woven portion of the scarf -- barely more than two yards total. What have you got in stash odds and ends that would work? Or perhaps you might like to club in on a skein with 100 friends? 

Recommended needle size
[always use a needle size that gives you the gauge listed below -- every knitter's gauge is unique] 
spacer US #2/2.75mm needles -- straight or short circular, as you prefer
spacer A spare needle of the same size

Notions
spacer 3-4 yards smooth, contrasting scrap yarn (for provisional cast-on, see Pattern Notes)
scissors 
spacer yarn needle

GAUGE
32 sts/32 ridges = 4 inches in garter stitch

PATTERN NOTES
[Knitty's list of standard abbreviations and techniques can be found here.]

Method. The collar is worked flat and joined into a tube using garter stitch grafting. If grafting really, truly scares you to death (it shouldn't) then you could join the ends with a three-needle bind off on the wrong side. It won't look quite as perfect; but I don't have to wear it so it's none of my business.

Garter Stitch Grafting. Not difficult -- in fact rather easier than its sibling, Kitchener Stitch -- but do be sure to take time after the graft is finished to gently tug and pull your grafted row with the tip of a needle until it perfectly matches the tension of the knitted rows. The method can be found at the end of thearticle.

Instructions for a three-needle bind off can be found here.

Provisional Cast-On. There are many methods for provisional cast-ons, but my favorite -- and the one employed in knitting the sample -- is extremely simple. Use your scrap yarn to CO the number of sts required, and k 3 rows; then join C1 and proceed as pattern dictates. To remove the CO, snip it near the edge with a pair of sharp scissors and unravel, placing the live sts on the second ndl as they are revealed.

Carrying Unused Colors. There is no way to avoid having a lot of ends to weave in, but you can eliminate a few of them by carrying the unused stripe color along the selvage of the work. This can be done only when the distance between color changes is four rows or fewer.

DIRECTIONS

spacer
Knitting the HorizontalsWith 1 circular ndl and scrap yarn, CO 74 sts. K 3 rows.

Join C1 and work in garter stitch as follows:

C1: 8 rows
*C2: 4 rows
C3: 2 rows
C2: 2 rows
C3: 2 rows
C2 : 2 rows
C1: 4 rows
C4: 2 rows
C2: 2 rows
C4: 2 rows
C3: 2 rows
C4: 2 rows
C2: 2 rows
C4: 4 rows
C1: 4 rows
C2: 2 rows
C3: 2 rows
C2: 2 rows
C3: 2 rows
C2: 4 rows
C1: 24 rows

Repeat from * twice more.

Fourth repeat: Work from * through final rows of C2. With C1, k 15 rows.

Remove provisional cast on, carefully placing revealed live sts on second circular ndl.

Break working yarn, leaving a length equal to three times the width of the work plus about 8 inches. Thread working yarn onto tapestry ndl and work garter stitch graft to join two sets of live sts.

When graft is complete, use tip of tapestry needle to adjust tension of grafted row to exactly match tension of knitted rows.

Weave in all ends on WS before proceeding to next step.

spacer
Weaving the Verticals
All 74 columns of sts created during the knitting of stripes will have a length of yarn woven through them to form the vertical stripes of the plaid. 

Begin at either CO or BO edge of the collar, and work column by column until you reach the other selvage.

You'll weave the following colors, in the following pattern, twice across the columns of stitches:
C1: 6 rounds
C2: 2 rounds
C5 : 1 round
C2: 1 round
C3: 1 round
C2: 1 round
C1: 2 rounds
C4: 2 rounds
C2: 1 round
C4: 1 round
C3: 1 round
C4: 1 round
C2: 1 round
C4: 2 rounds
C1: 2 rounds
C2: 1 round
C3: 1 round
C2: 1 round
C5: 1 round
C2: 2 rounds
C1: 6 rounds

Begin each round by threading a suitable length -- about 30 inches -- of yarn up from the WS of the fabric. End the round by bringing the weaving yarn down through the fabric to the WS, immediately adjacent to the spot from which it began.

Weave the yarn up and down over the garter ridges: weave over a garter bump of one ridge, then under a garter bump in the following ridge. The weaving yarn does not penetrate the fabric completely, but only goes over and under the surface bumps. (One the WS, you will see only knitting, no weaving.)

富兰克林格子脖套 - maomao - 我随心动

Be sure to alternate which bumps are woven over, and which are woven under, with each successive round of weaving.

Start a new length of yarn for each woven round, even if successive rows are in the same color. Weaving rounds may be started anywhere on the round. I recommend that you vary your starting points so as not to wind up with one narrow portion of the collar in which all the loose ends will be buried -- this would tend to cause distortion on the RS of the fabric.

Take care that the tension of your woven rounds is even. The weaving yarn should lie gently and neatly on the surface of the fabric. It should not form loose loops, and neither should it pull the fabric into puckers. Before weaving in ends, a gentle stretch around the circumference of the collar should help to settle the weaving nicely.

FINISHING
Weave in the ends of the woven strands on WS. Soak and gently block. Allow to dry completely before wearing.




http://www.ravelry.com/patterns/library/princess-franklin-plaid-collar
http://www.knitty.com/ISSUEw13/FEATw13SIT.php
  评论这张
 
阅读(10)| 评论(0)
推荐 转载

历史上的今天

在LOFTER的更多文章

评论

<#--最新日志,群博日志--> <#--推荐日志--> <#--引用记录--> <#--博主推荐--> <#--随机阅读--> <#--首页推荐--> <#--历史上的今天--> <#--被推荐日志--> <#--上一篇,下一篇--> <#-- 热度 --> <#-- 网易新闻广告 --> <#--右边模块结构--> <#--评论模块结构--> <#--引用模块结构--> <#--博主发起的投票-->
 
 
 
 
 
 
 
 
 
 
 
 
 
 

页脚

网易公司版权所有 ©1997-2017